Table of Contents
Advertisement
Installing the Projector
c
Pull the lens unit straight out as it is released.
Installation Settings
Setting the direction
When installation is complete, set the Direction from the configuration
menu according to the vertical installation angle.
Attention
Make sure you set Direction correctly. The lamp's operating life may be
reduced if it is not set.
a
Press the [Menu] button while projecting.
b
Select Direction from Extended.
c
Use the [ ][ ] buttons to set the projector's installation angle.
Each time you press one of the buttons, the angle of tilt changes by
15 degrees. Set as close to the actual setup angle as possible.
90
45
0
-45
-90
26
135
180
-135
Advertisement
Table of Contents
