Table of Contents
Advertisement
Adjusting Projected Images
When selecting Vertical Corner:
Adjust the left and right based on the point nearest to the vertical
line in the center of the screen.
a
If the [Esc] button is pressed for approximately two seconds,
the confirm default reset screen is displayed.
Select Yes to reset the result of Corner Wall.
i
Use the [
][
][ ][ ] buttons to adjust the shape.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
j
Repeat procedures 8 and 9 as needed to adjust any remaining
parts.
If the image expands and contracts, go to the next step and adjust
the linearity.
k
Press the [Esc] button to display the screen from step 4. Select
Linearity, and then press the [
] button.
l
Use the [ ][ ] buttons to adjust the linearity.
Correct it so that the distance between lines is equal.
When the [ ] is pressed
When selecting Horizontal Corner
When the [ ] is pressed
When selecting Horizontal Corner
m
To complete the corrections, press the [Menu] button.
a
You can fine tune the results of Corner Wall using Point Correction.
Change Geometric Correction to Point Correction, and then make
adjustments after selecting Keep the current geometric correction
settings.
s "Point Correction"
p.61
70
When selecting Vertical Corner
When selecting Vertical Corner
Advertisement
Table of Contents
