Fujitsu M10-4 Service Manual page 36

Location number
3
Use the BB-ID switch to set the BB-ID number of the SPARC M10-4S. Set #0 to #15 for
the SPARC M10-4S.
Table 2-5 How to operate the BB-ID switch
Operation
Pressing the + side.
Pressing the - side
Use the mode switch to set the operation mode for the system. The Locked and
Service operation modes can be switched by sliding the mode switch.
Table 2-6
Table 2-6 Functions of the mode switch
Icon
Use the power switch to start or stop the system. The system starts/stops differently
depending on how the power switch is pressed.
Table 2-7
switch is pressed.
Table 2-7 Functions of the power switch
Icon Operation
Brief press
(For 1 second or
more and less than 4
seconds)
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ November 2014
22
Component
Power switch
Table 2-5 describes how to operate the BB-ID switch.
Description
The BB-ID number increases by 1.
The BB-ID number decreases by 1.
describes the difference between the modes.
Name Description
Locked mode This mode is used for normal operation.
- The power switch can be used to start the system but not to
stop it.
Service mode This mode is used for maintenance.
- The power switch cannot be used to start the system but can be
used to stop it.
- Place the system in Service mode to perform maintenance
work with the system stopped.
describes how system starts/stops vary depending on how the power
Description
If the system has been
started in Service mode
(*1):
If the system is stopped in
Service mode:
If the system has been
started in Locked mode
(*1):
Operation is ignored.
Operation is ignored.
Operation is ignored.