Starting The System From The Operation Panel - Fujitsu M10-4 Service Manual
Hide thumbs
Also See for Fujitsu M10-4:
- Service manual (514 pages) ,
- Safety and compliance manual (63 pages) ,
- Service manual (388 pages)
Table of Contents
Advertisement
6.8.2
Starting the system from the operation panel
1.
Check that the XSCF STANDBY LED on the operation panel is on.
2.
Press the power switch on the operation panel for 1 second or more (less
than 4 seconds).
For details, see
Note - For a building block configuration, press the power switch on the master chassis. The
power switches of the other chassis are disabled.
3.
Confirm that the POWER LED on the operation panel is on.
4.
Execute the showpparstatus command to confirm that the power to all the
physical partitions in the system is turned on.
"2.3.2 Control function of the operation
panel."
Chapter 6 Restoring the System
109
Advertisement
Table of Contents
Troubleshooting
