Installing A Power Supply Unit - Fujitsu M10-4 Service Manual

Figure 12-2 Screws securing power supply unit
3.
Hold the lever and pull the power supply unit out of the chassis.
4.
Support the power supply unit from below with one hand and remove it
carefully from its slot.
Note - Place the removed power supply unit on a grounded antistatic ESD mat.
12.3

Installing a Power Supply Unit

This section describes the procedure for installing a power supply unit.
1.
Support the power supply unit from below with one hand and insert it
carefully into its slot.
Note - Do not forcibly push the power supply unit into its slot. Using excessive force may
damage the component or the chassis.
2.
Firmly push the power supply unit into its mounting position.
3.
Close the lever and then tighten the screws.
4.
Connect the power cords to the power supply unit.
Chapter 12 Maintaining the Power Supply Units 265