D.3
SAS Port
The SAS port of the SPARC M10-4/M10-4S is used to connect external devices with
an SAS interface, such as a tape drive. The chassis has one SAS port on the rear.
Consult a service engineer for more information about compatible devices.
D.4
RESET Switch
The RESET switch of the SPARC M10-4/M10-4S is an emergency switch to restart the
XSCF. For how to use the RESET switch, see "17.2 Notes on Using RESET Switch" in
the Fujitsu M10/SPARC M10 Systems System Operation and Administration Guide.
Figure D-2
indicates the RESET switch location of the SPARC M10-4S. The RESET switch (A in
the figure) is located on the rear of the chassis.
Figure D-2 RESET switch location (SPARC M10-4)
indicates the RESET switch location of the SPARC M10-4 while
A
Appendix D External Interface Specifications
Figure D-3
325