Fujitsu M10-4 Service Manual page 169

Figure 7-23 Active/hot removing flow (for an internal disk)
1. Open rack door
2. Check operating condition of system and
I/O device usage status
3. Enable removal of internal disk
4. Remove internal disk for removal
5. Confirm that there is no problem with chassis
after removal
6. Close rack door
Table 7-24 Active/hot removal work procedure (for an internal disk)
Item
Work procedure
1 Opening the rack door
2 Checking the operating condition of
the system and the I/O device usage
status
3 Enabling the removal of an internal
disk
4 Removing an internal disk for removal
5 Confirming that there is no problem
with the chassis after the removal
6 Closing the rack door
Note - You can perform the active/hot removal work for an internal disk only in a RAID
configuration.
Removal complete
Reference
"5.3 Checking the Operating Condition and Resource Usage
"5.4.2 Enabling the removal of an I/O
removal of an internal
"Chapter 10 Maintaining the Internal
"4.2.2 Identifying a
device" -
disk"
Disks"
failure" - "Checking the FRU
Chapter 7 Maintenance Flow
Status"
"Enabling the
status"
155