Fujitsu M10-4 Service Manual page 130

Figure 7-3 Active/hot replacement flow (for an internal disk in a RAID
1. Open rack door
2. Identify faulty internal disk
3. Replace internal disk
4. Incorporate replaced internal disk into system
5. Confirm that there is no problem with
replaced FRU
6. Close rack door
Table 7-4 Active/hot replacement work procedure (for an internal disk in a RAID configuration)
Item
Work procedure
1 Opening the rack door
2 Identifying a faulty internal disk
3 Replacing a faulty internal disk
4 Incorporating the replacement internal disk
into the system
5 Confirming that there is no problem with
the replacement FRU
6 Closing the rack door
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ November 2014
116
configuration)
Maintenance complete
Reference
"14.2.9 Checking for a failed disk drive" in the Fujitsu
M10/SPARC M10 Systems System Operation and Administration
Guide
"Chapter 10 Maintaining the Internal
"14.2.10 Replacing a failed disk drive" in the Fujitsu
M10/SPARC M10 Systems System Operation and Administration
Guide
"4.2.2 Identifying a
Disks"
failure" - "Checking the FRU status"