Table of Contents
Advertisement
3 Copy
Step 3 Entering a Quantity
The following describes how to enter the number of copy sets. You can enter up to
9999 sets.
1
Enter the number of copies using the numeric
keypad.
The number of copies entered appears on the
upper right of the touch screen.
2
If you have entered an incorrect value, press the
<C (Clear)> button and then enter the correct
value.
3
Step 4 Starting the Copy Job
The following describes how to start a copy job.
1
Press the <Start> button.
Important • If the document has been loaded in the
If you have more documents
If you have more documents to copy, select [Next
Original] on the touch screen while the current
document is being scanned. This allows you to scan the documents as a single set of
data.
2
Select [Next Original] while scanning is in
progress.
Note
54
document feeder, do not hold down the
document while it is being conveyed.
• Copies cannot be made if a copy protection
code is detected. For information on copy
protection codes, refer to "Secure Watermark
(Managing Document Security)" (P.109).
• When using the document feeder, load
the next document after the machine has
finished scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no
operation is performed for a certain period
of time, the machine automatically
assumes that there are no more documents.
• You can change the number of copies by selecting [Change Quantity] that is displayed after
selecting [Delete].
Numeric keypad
<C (Clear)> button
<Start> button
Advertisement
Table of Contents
