Table of Contents
Advertisement
Staple
The number of sheets that can be stapled is 2 - 100 (when 80 gsm paper is used).
Available paper types are: Plain (64 - 105 gsm), Pre-Printed (64-105 gsm), Plain -
Special 1 (64 - 105 gsm), Pre-Printed SP1 (64-105 gsm), Recycled (64 - 105 gsm),
Recycled - Special 1 (64 - 105 gsm), Plain Reload (64 - 105 gsm), Plain ReloadSP1
(64 - 105 gsm), Punched (64 - 105 gsm), Lightweight (52 - 63 gsm), LW Pre-Printed
(52 - 63 gsm), Heavyweight (106 - 216 gsm), HW Pre-Printed (106 - 216 gsm),
Heavyweight SP1 (106 - 216 gsm), HW Pre-Printed SP1 (106 - 216 gsm), Tab Stock
(106 - 216 gsm), and Custom Paper 1 to 5. If paper heavier than 90 gsm is used,
outputs may not be stapled correctly even if the number of sheets is 100 or less.
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
setting on the [Layout Adjustment] screen.
• In the following cases, the actual stapling position differs from the stapling position displayed
on the screen:
• When [Original Orientation] is set to [Upright Images], and [Staple] is set to one position
at the right side.
• When [Original Orientation] is set to [Sideways Images], and [Staple] is set to one
position at the left side.
Hole Punch
Specify the position for punching. You can select from six different punch positions: 2
Holes, 2 Holes Top, 2 Holes Right, 4 Holes, 4 Holes Top, 4 Holes Right.
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
setting on the [Layout Adjustment] screen.
Original Orientation
Allows you to specify the orientation of the document so that the machine can identify
the top of the document.
Note
• If the [Original Orientation] setting differs from the actual document orientation, the machine
may not detect the top of the document correctly.
Upright Images
Select this option when placing the top edge of the document against the top side of
the document glass or document feeder.
Sideways Images
Select this option when placing the top edge of the document against the left side of
the document glass or document feeder.
Z Fold Half Sheet
The machine folds the output copies in Z fold. Z fold can be applied to B4, A3, 11 x 17".
If you have mixed sized documents, the width (vertical direction) of the paper must be
the same, such as a combination of A4 (portrait) and A3 (landscape), and a
combination of B5 (portrait) and B4 (landscape). For example, if you have a
combination of A4 (portrait) and A3 (landscape), the Z fold is only applied to A3.
Output/Offset
Allows you to select the output destination tray and offset operation.
Offset Stacking
This option is displayed if you select [Right Middle Tray] or [Stacker - Stacker Cart]
for the output destination.
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations.
You can specify by set, job, specified number of pages, or specified number of
copies for a paper stack.
Output Format
3
119
Advertisement
Table of Contents
