Table of Contents
Advertisement
1
Remove any paper clips and staples before
loading a document.
2
Adjust document guides to match the size of
the document loaded.
Note
• When loading a large size document such
3
Load the document face up (when the
document is 2-sided, place the front side up)
in the center of the document feeder.
Note
• The Confirmation indicator lights up when
When the document is loaded in the document feeder,
the document feeder tray lifts up. You can set the
timing of the lift. For more information, refer to "5
Tools" > "Common Service Settings" > "Other
Settings" > "Document Feeder Tray Elevation" in the
Administrator Guide.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with
sizes from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard
size documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard
document size, refer to "Original Size (Specifying a Scan Size)" (P.196).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on the paper size settings, refer to "5 Tools" > "Common
Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
1
Open the document cover.
Important • Ensure that the touch screen is active,
as A3, lift up the document feeder tray,
and open the document stopper
rightward.
the document is loaded correctly.
and then load a document. Otherwise, the
machine may not properly detect the
document size.
Scanning Procedure
Document stopper
Confirmation indicator
4
137
Advertisement
Table of Contents
