Lucent Technologies MDW 9031DCP Installation And Use Manual page 89

Handset
Enabling or Disabling
the Alerter
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
The alerter is an audible signal to notify you of an incoming call. If a call comes in
while the phone is idle, the handset rings. If you are already on a call, the handset
chirps softly. You can adjust the volume of the alerter by pressing the "+" button or
the "-" button on the side of the handset when the phone is turned off. You can enable
or disable the alerter using the following procedure:
1 Make sure the handset is turned off.
Press and hold the Select button ( " ) for three seconds.
2
3 While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating
you are in Local Mode. (While in Local Mode, the MDW 9031/9031DCP can still
receive notification of incoming calls.)
If the alerter is disabled, the No Ring icon (a bell with a line through it) appears in
the second line of the display. For example:
If the alerter is enabled, the icon is not displayed. For example:
Press "A" (2) on the dialpad to enable or disable the alerter.
4
Press O to exit Local Mode.
5
Note: Both the alerter and the vibrator can be disabled at the same time. In this
case the only notification you have of an incoming call is that a line status
indicator (a truncated triangle or a rectangle, depending on your
communications system) flashes in the display.
Using the MDW 9031/9031DCP Pocket Phone
ON
ON
3
Issue 3 October 1999 81