Lucent Technologies MDW 9031DCP Installation And Use Manual page 53

Installing Multiple Carriers
If the carriers are plugged
into...
one surge suppressor strip
wall outlets
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
10 Plug each carrier's power cord into one of the following power sources that is not
controlled by an on/off switch:
Surge-suppressor strip.
~
Properly grounded, 3-prong wall outlets. (See "wall outlets" in the following
~
chart for the order in which to power up the carriers.)
Power the carriers as follows:
11
Then...
Power the strip.
Result: All the carriers will turn on simultaneously.
Plug in the power for the carriers in this order:
T RANS T ALK
O N
CAU TI
ONLY USE E
CABL AT&T 7896
84766 P⁄N I N
OUT
OF SYN C
OUT
1 2 3 4 5 6
Control
Expansion
Carrier
Carrier #1
1
!
CAUTION:
Never connect or disconnect expansion cables or telephone line cords, or
insert or remove radio modules, while the carrier is plugged into the wall
outlet.
12 Go to "Multiple Carrier Mounting and Cabling Self-Test" (page
Installing the MDW 9031/9031DCP Pocket Phone
T RANS T ALK T RANS T ALK
O N O N
CAU TI CAU TI
USE ONLY E ONLY USE E
AT&T 7896 CABL AT&T CABL 7896
P⁄N 84766 I N P⁄N 84766 I N
OUT OUT
OF SYN C OF SYN C
OUT OUT
1 2 3 4 5 6 1 2 3 4 5 6
Expansion
Carrier #2
2 3
T RANS T ALK T RANS T ALK
O N O N
CAU TI CAU TI
USE ONLY E USE ONLY E
AT&T 7896 CABL AT&T CABL 7896
P⁄N 84766 I N 84766 P⁄N I N
OUT OUT
OF SYN C OF SYN C
OUT OUT
1 2 3 4 5 6 1 2 3 4 5 6
Expansion Expansion
Carrier #3
Carrier #4
4
5
46).
Issue 3 October 1999 45
2