Lucent Technologies MDW 9031DCP Installation And Use Manual page 105

Removing Radio Module from Carrier
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
Maintaining the MDW 9031/9031DCP Pocket Phone
5 If you removed a radio module from Slot 6 of an 117A3 control carrier, you must
insert another radio module into this slot. Failure to do so will cause the carriers
to be unsynchronized.
6 Repower the carrier. If you have multiple carriers, repower them in order from
left to right, as shown below:
T RANS T ALK
O N
CAU TI
USE ONLY E
AT&T CABL 7896
P⁄N 84766 I N
OUT
OF SYN C
OUT
1 2 3 4 5 6
Control
Expansion
Carrier
Carrier #1
1
Wait a few seconds, then verify that the carrier's OUT OF SYNC LED is not lit.
7
If the LED is lit, power down, wait at least 15 seconds, and then repower the
carrier. If the LED is still lit, follow the suggestions in the "Installation Problems"
section of Chapter 5, "Troubleshooting." If the LED is still lit, call Customer
Support as described in the Copyright and Legal Notices at the beginning of this
book.
4
T RANS T ALK
CAU TI O N
ONLY E
USE CABL 7896
AT&T P⁄N 84766
I N
OUT
OF SYNC
OUT
1 2 3 4 5 6
For any Model 117A4 carriers, verify that the CONTROL/EXPANSION LED is
8
lit. For the control carrier, this LED is green. For an expansion carrier, this LED is
amber.
Reset the receiver and alerter volumes that reverted to the default settings when
9
the system was powered down (see "Changing the Handset Settings" in
Chapter 3).
T RANS T ALK T RANS T ALK
O N O N
CAU TI CAU TI
USE ONLY E USE E ONLY
AT&T CABL 7896 AT&T 7896 CABL
P⁄N 84766 I N 84766 P⁄N I N
OUT OUT
OF SYN C OF SYN C
OUT OUT
1 2 3 4 5 6 1 2 3 4 5 6
Expansion
Carrier #2
2 3
Y N C
O F S
L /
O U T
T R O
C O N
I O N
A N S
E X P
T RANS T ALK T T
RANS ALK
O N O N
CAU TI CAU TI
ONLY USE E ONLY USE E
CABL AT&T 7896 AT&T CABL 7896
P⁄N 84766 I N P⁄N 84766 I N
OUT
OUT
OF SYN C C
OUT OF SYN
OUT
1 2 3 4 5 6 1 2 3 4 5 6
Expansion Expansion
Carrier #3 Carrier #4
4 5
Issue 3 October 1999 97
4