Lucent Technologies MDW 9031DCP Installation And Use Manual page 88

3
Using the MDW 9031/9031DCP Pocket Phone
Enabling or Disabling
Backlighting
80 Issue 3 October 1999
3 While still holding ", press O.
The handset beeps twice, and the display shows the handset settings, indicating
you are in Local Mode. (While in Local Mode, the MDW 9031/9031DCP can still
receive notification of incoming calls.)
If Line Preselection is enabled, PSEL appears on the top line of the display. For
example:
If Line Preselection is disabled, no icon appears.
Press and hold "P" (7) for three seconds.
4
The handset display shows PRESELECTION:ON if Line Preselection is
enabled or PRESELECTION:OFF if Line Preselection is disabled. For
example:
To toggle between ON and OFF to enable or disable Line Preselection, press ".
5
To exit Local Mode, press O.
6
Backlighting for the display is factory set to ON for the MDW 9031/9031DCP Pocket
Phone. To toggle the Backlighting features OFF (and ON), use the following
procedure:
Make sure the handset is turned off.
1
2 Press and hold the Select button ( " ) for three seconds.
While still holding ", press O.
3
The handset beeps twice, and the display shows the handset settings, indicating
you are in Local Mode. (While in Local Mode, the MDW 9031/9031DCP can still
receive notification of incoming calls.)
a Press "L" (5) for "Lighting." The Backlighting toggles ON or OFF each time
you press the 5.
After setting the correct Backlighting state, press O for normal Pocket
b
Phone use.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
Handset