Lucent Technologies MDW 9031DCP Installation And Use Manual page 70

2
Installing the MDW 9031/9031DCP Pocket Phone
62 Issue 3 October 1999
4 Press and hold "M" (6) for three seconds to enter Button Mapping Mode.
The handset display shows one of the following:
MAP:P
MAP:D
MAP:M1
MAP:M2
Press " repeatedly to cycle through the settings until the display appropriate
5
for your communications system is shown.
Press O when the correct setting is displayed.
6
The top line of the display shows information appropriate to the communications
system you are using.
To verify your setting, repeat Steps 1–3. The top line of the display should appear
7
as follows, depending upon your communications system:
PARTNER Systems
DEFINITY Systems, System 25, System 75, and
System 85
All MERLIN Systems (except MERLIN 410 and
MERLIN 820), including MERLIN LEGEND
MERLIN 410 and MERLIN 820
For a description of the button mapping between the MDW 9031/9031DCP Pocket
Phone and the wired telephones for your communications system, or to program
features on buttons, see the appropriate "Button Mapping" topics in Chapter 6.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
PARTNER Systems
DEFINITY Systems, System 25, System 75, and
System 85
Note:
The MDW 9031DCP should only be set
to MAP:D for DEFINITY.
All MERLIN Systems (except MERLIN 410
and MERLIN 820), including MERLIN LEGEND
MERLIN 410 and MERLIN 820
Handset
LCL:P
LCL:D
LCL:M1
LCL:M2