Lucent Technologies MDW 9031DCP Installation And Use Manual page 60

2
Installing the MDW 9031/9031DCP Pocket Phone
52 Issue 3 October 1999
3 At this stage of your installation, verify that the LEDs displayed match the first or
fourth lines of the SYNC and CONTROL/EXP LED Codes label.
4 If an OUT OF SYNC LED is lit, power down, wait at least 15 seconds, and then
repower the carriers in order from left to right, as described in Step 8 in
"Installing a Single Radio Module in Each Carrier." If the LED is still lit, follow
the suggestions in the "Installation Problems" section of Chapter 5,
"Troubleshooting." If the LED is still lit, call Customer Support as described in
the Copyright and Legal Notices at the beginning of this book.
4 RANS T T ALK
O N
CAU TI
USE CABL ONLY E
AT&T 84766 7896
P⁄N I N
OUT
OF SYNC
OUT
1 2 3 4 5 6
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
Y N C
O F S
L /
O U T
T R O
C O N
I O N
A N S
E X P
Installing Multiple Carriers