Lucent Technologies MDW 9031DCP Installation And Use Manual page 86

3
Using the MDW 9031/9031DCP Pocket Phone
Local Mode also gives you access to Local Test Mode (which enables you to test the alerter, vibrator, and
display) and Wireless Test Mode (which enables you to test sound clarity, signal strength, and voice quality).
While in Local Mode, the MDW 9031/9031DCP can still receive notification of incoming calls.
To access Local Mode, use the following procedure:
Changing the
Communications
System Button
Mapping Setting
Enabling or Disabling
the Vibrator
78 Issue 3 October 1999
• Line Preselection
Backlighting
•
• Alerter
1 Make sure the handset is turned off.
Press and hold the Select button ( " ) for three seconds.
2
3 While still holding ", press O.
The handset beeps twice, and the display shows the handset settings. For
example, the following display indicates that the handset:
Is using button mapping for a PARTNER switch.
~
~ Has the vibrator and Line Preselection enabled.
~ Has the alerter disabled.
To exit Local Mode, press O.
4
If the MDW 9031/9031DCP Pocket Phone is set to use the wrong communications
system, an error message saying CHANGE BUTTN MAP shows on the top line of
the handset display each time the O button is pressed. If you see this message, use
the procedure described in "Changing the Communications System Setting" in
Chapter 2 to specify the correct communications system setting.
The vibrator vibrates to alert you to an incoming call in situations where you do not
want to disturb others with an audible ring. You can enable or disable the vibrator
using the following procedure:
Make sure the handset is turned off.
1
2 Press and hold the Select button ( " ) for three seconds.
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
Handset