Lucent Technologies MDW 9031DCP Installation And Use Manual page 36

2
Installing the MDW 9031/9031DCP Pocket Phone
The following chart explains the label that identifies the jacks and LEDs on the 117A4 carrier. (The IN and OUT
jacks and the OUT OF SYNC LED also appear on the 117A3 carrier.)
Label
IN
OUT
OUT OF SYNC
CONTROL/EXPANSION
28 Issue 3 October 1999
Explanation
Designates the modular jack that accepts the
modular plug and cable from the preceding
carrier to the left. If the jack is in use, this
carrier is an "expansion" carrier.
Designates the modular jack that accepts a
modular plug and cable to connect this
carrier to the next carrier to the right. This
carrier can be either a "control" carrier (if it
is the leftmost carrier) or an "expansion"
carrier.
Designates the upper of two LEDs. If the
LED is not lit, the carrier is "in sync."
If the LED glows red, the carrier is out of
synchronization. Call Customer Support as
described in the Copyright and Legal
Notices at the beginning of this book.
Designates the lower of two LEDs. The
color of the LED indicates the carrier
configuration:
Control carrier = green LED
Expansion carrier = amber LED
The light pattern indicates whether the
carrier is operational:
Glowing steadily = no problem
Blinking = no radio module(s) in the carrier
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
Understanding Carriers