Lucent Technologies MDW 9031DCP Installation And Use Manual page 133

MDW 9031 Compatibility
Setting the Line
Ringing Options for
PARTNER Systems
Telephone
Communications
System
PARTNER
PARTNER Plus
PARTNER II
PARTNER Advanced
Communications System
The MDW 9031 does not have a speaker; therefore, it does not support voice announce/page and call groups.
MERLIN Systems
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use 503-801-166
Use the following guidelines to ensure optimal voice quality when using MDW 9031
Pocket Phones with a PARTNER, PARTNER Plus, PARTNER II, or PARTNER
Advanced Communications System in key mode:
Note:
For PARTNER II hybrid systems that use pooled lines, set the Line
Ringing options as described in the following table if more than six
MDW 9031 Pocket Phone handsets have the same pooled line
appearance.
TransTalk 9000 System with
Two Carriers (one control and
one expansion carrier)
1 Set Line Ringing for each
extension that has a radio
module in the control carrier to
Ring.
Set Line Ringing for each
2
extension that has a radio
module in the expansion carrier
to No Ring. (Install an external
audible alert for these
extensions.)
1 Set Line Ringing for each
extension that has a radio
module in the control carrier to
Ring.
Set Line Ringing for each
2
extension that has a radio
module in the expansion carrier
to Delayed Ring.
• On MERLIN II and MERLIN LEGEND Systems, you must connect your
wireless phone to an available jack on either a 408 outside line/analog telephone
module or an 008 analog telephone module.
Since the MDW 9031 does not have a speaker function, the Voice Announce
•
feature must be disabled. It is recommended that you use MERLIN 206/410/820
Systems installed with Feature Package 2 with your wireless phone, so that you
can disable that feature.
• Since the MDW 9031 has no speaker function, it should not be assigned to a
paging group.
MDW 9031/9031DCP Pocket Phone Compatibility
TransTalk 9000 System with Three
Carriers (one control and two
Not applicable; PARTNER supports up
to 12 phones.
1 Set Line Ringing for each extension
that has a radio module in the control
carrier to Ring.
Set Line Ringing for each extension
2
that has a radio module in the
expansion carrier #1 to Delayed
Ring.
3 Set Line Ringing for each extension
that has a radio module in the
expansion carrier #2 to No Ring.
(Install an external audible alert for
these extensions.)
expansion carriers)
Issue 3 October 1999 125
6