Table of Contents
Advertisement
CDM-740 Advanced Satellite Modem
Flash Upgrading
The downloadable files are stored in two formats: *.exe (self-extracting) and *.zip
(compressed). Some firewalls will not allow the downloading of *.exe files. In this case,
download the *.zip file instead.
For additional help with "zipped" file types, refer to PKZIP for Windows, WinZip, or
ZipCentral help files. PKZIP for DOS is not supported due to file naming conventions.
4. Extract the files into the temporary folder on the PC. At least two files should be extracted:
•
FW-0000279x.bin, where "x" is the version (bulk image file).
•
CDM-740_ReleaseNotes_vXXX.pdf, where "XXX" denotes the firmware version.
5. Confirm that the files have been extracted to the specified temporary folder on the PC. In
DOS, use "cd c:\temp" to change to the temporary directory created in Step 2, then use the
"dir" command to list the files extracted from the downloaded archive file.
6. Connect the external PC to any one of the four CDM-740 modem 10/100 Ethernet ports, via
a hub or a switch, or directly to a PC with a crossover cable.
7. Send a "ping" command to the modem to verify the connection and communication.
First, determine the IP address of the modem remotely or using the front panel:
•
Remotely - use the <0/IPA? command
•
Front panel - use the
menu.
Then, using DOS to PING (and FTP): Click "Start" on the Windows toolbar, then select the
"Run..." option. As an alternative, use the "DOS Prompt" or "Command Prompt" icons in
the Start Menu:
•
Using Win95 or Win98: Type "command".
•
Using WinNT, Win2K or WinXP: Type "cmd".
At the DOS prompt, type "ping xxx.xxx.xxx.xxx" (where "xxx.xxx.xxx.xxx" is the modem IP
address). The results should confirm whether or not the modem is connected and
communicating.
8. Initiate an FTP session with the modem (the example uses a DOS window):
a. From the PC, type "ftp xxx.xxx.xxx.xxx" where "xxx.xxx.xxx.xxx" is the IP address of
the CDM-740.
b. Press ENTER at the user prompt.
c. Verify the FTP transfer is binary by typing "bin".
d. Type "prompt" then type "hash" to facilitate the file transfers.
9. Transfer the files: Type "put FW-0000279*.bin:" to begin the file transfers. It will take a
few seconds to transfer the file.
10. Verify the file transfer.
a. The PC should report that the file transfer has occurred, and the display on the
modem will report:
SELECT: Config
... FTP Upgrade In Progress ...
... Please wait ...
4–3
IP
GE1 / GE2 / Mgmt
Revision 0
MN-CDM740
Addr/Range
Advertisement
Table of Contents
