Displaying Video Data - Sony SRPC-5 Operation Manual

Automatic changes in the VTR SETUP menu
settings that occur during VTR operations
conducted through the web application
The settings of the following items in the VTR SETUP
menu of the SRW-5800 will be changed automatically, as
indicated below, when the respective VTR operations are
conducted through the web application.
• Import or export of files
- Menu item "606: TCG MODE select" changes to
"regene".
- Menu item "607: TCG REGENE SOURCE select"
changes to "int-LTC".
• First Rec (first recording operation)
Menu item "601: DF/NDF MODE select" changes to
"drop frame" or "non-drop frame" according to the
setting on the web application.
• Any VTR operation (including import and export)
- Menu item "005: SERVO AV REFERENCE select"
1)
changes to "input" .
- Menu item "602: TIMER MODE select" changes to
"TC".
- Menu item "A10: 9-pin TC sense select" changes to
"LINE".
1) It is recommended that you leave the "input" specification as is during
use of the networking function of the SRPC-5.
VTR SETUP menu settings to prevent import or
export failure
During import or export, the SRW-5800 repeats "run and
stop" movement. If the SRW-5800 enters standby off
mode while stopped (in STILL status) during import or
export, the SRW-5800 may fail to servo-lock by the time
it reaches the next IN point. This will cause the import or
export operation to be canceled. To prevent this, it is
recommended that menu item "501: STILL TIMER" in the
VTR SETUP menu of the SRW-5800 be set to eight
minutes (the default setting) or longer.
If the same problem occurs due to extremely slow network
speed, etc., the menu item "501: STILL TIMER" setting
should be even longer to prevent the SRW-5800 from
entering tape protection mode while in stop (STILL)
status.
Downconverter Settings
Configure downconverter settings for outputting
downconverted VTR data to the monitor or for recording
downconverted data when copying to the VTR.
Downconverter settings are configured in the DC SETUP
tab screen of the DISK SETUP menu.
Refer to the operating instructions for the HKSR-5804 for
more details.

Displaying Video Data

You can view video data stored on a SRMemory card or
VTR via a web browser or HD monitor connected to the
unit by accessing the VTR MEM CONTROL tab screen
from the video data's HOME, IMPORT, or EXPORT
menu.
Using the control buttons in the VTR MEM CONTROL
tab screen, you can perform video data operations such as
play, pause, fast forward, and rewind.
You can display a jog dial and adjust the size of the proxy
screen for the GUI of the VTR MEM CONTROL tab
screen. The GUI is configured with the GUI TYPE setting
in the PROXY SETUP tab screen of the PROXY SETUP
menu (see page 15).
In VTR mode, the VIEWER button appears on the right
side of the web application screen. The VIEWER window
appears when this is clicked.
The video data controls available in the VTR MEM
CONTROL screen are also available in the VIEWER
window.
Differences in the VTR MEM CONTROL
window during processing of compressed
data and uncompressed data
When processing compressed data (HDCAM-SR format),
the current position on the tape is displayed by the
timecode. When processing uncompressed data (DATA
format), the current position on the tape is displayed in
picture IDs instead of the timecode. A picture ID consists
25
VTR Video Data Operations