Table of Contents
Advertisement
• When the web application of the unit is used, the
[Return] and [Update] buttons in the browser menu do
not operate. If the display of the browser cannot be
updated or abnormality has occurred in the display
contents, do not click the [Update] button. In this case,
re-enter the IP address of the unit.
If you forget the IP address
If you forget the IP address of the unit, turn the unit off and
perform the following to restart the unit.
1
Hold down the eject button ([PC5]) or UNLOCK
button ([PC4]), and press the on/standby button.
2
Release the button when the STATUS indicator starts
to blink blue.
The unit starts up in default IP address mode, and the IP
address is reset to the factory default address, 192.168.0.1.
Enter this address in the web application to connect to the
unit, and verify or reconfigure the IP address as necessary.
Network Settings
Configure the unit's IP address and other settings.
Note
When opening the web application and configuring
network settings for the first time, enter "192.168.0.1" in
the address bar of your web browser to display the web
application screen.
1
Click the DIAGNOSIS menu button in the web
application screen, and click the NETWORK tab.
The NETWORK tab screen appears.
After entering values for each item in the following
screen, press the Enter key and click the SET button to
confirm the values.
The settings will be applied after you finish
configuration and restart the unit.
2
Configure the following items under NETWORK.
IP ADDRESS: IP address of the unit.
SUBNET MASK: Subnet mask of the unit.
MTU: Maximum transfer volume for data in bytes.
Note
[PC5] When connecting the SRPC-5 to the VTR, set an
IP address that differs to the HKSR-5804's address.
3
If necessary, configure the following items under
DOMAIN.
DOMAIN NAME: Network domain name.
DNS SERVER 1: IP address of DNS server 1.
DNS SERVER 2: IP address of DNS server 2.
DNS SERVER 3: IP address of DNS server 3.
DNS SERVER 4: IP address of DNS server 4.
4
Configure the following items under OTHERS.
DEFAULT GW: Default gateway of the unit.
HOST NAME: Host name of the unit.
UID: User ID of the unit.
GID: Group ID of the unit.
Note
Be sure to consult the file server administrator before
entering the appropriate values for UID and GID.
If you are transferring data through means other than the
NETWORK connector on the rear of the unit, configure
13
Setup
Advertisement
Table of Contents
