Table of Contents
Advertisement
Names and Functions of Parts
Front
SRPC-5
1 2 3 4
SR-PC4
1
2
4
a On/standby button
[PC5] When the main power switch on the rear of the unit
is turned on, this turns on the unit or sets it to standby
mode.
[PC4] Turns the unit on/off.
The button will light or blink based on the operating status
of the unit.
Lit red: The unit is in standby mode.
Blinking green: The unit is starting up.
Lit green: The unit is turned on.
Blinking green: If the button blinks green after startup,
the unit may be malfunctioning.
Blinking red: [PC4] If the button is blinking red before
the unit is turned on, the power supply voltage may be
incorrect.
If the button blinks green after startup or blinks red, stop
operation and contact your local Sony representative.
b STATUS indicator
Displays the status of the unit.
Lit green: Operating normally.
Blinking green: The unit is starting up.
Lit yellow: A warning has occurred.
10
Names and Functions of Parts
Lit red: An error has occurred.
Blinking blue: The unit is starting up in default IP
c [PC5] VTR indicator
Displays the connection status between the SRPC-5 and
5
6
7
the VTR.
Off: The SRPC-5 is set to stand-alone mode or a VTR is
Lit green: The SRPC-5 is properly connected to the VTR
Lit yellow: A warning has occurred on the VTR.
Lit red: An error has occurred on the VTR.
Blinking red: The unit cannot connect to the VTR or
6
d NETWORK indicator
7
Displays the communication status between the unit and
the server.
Off: The server is not mounted.
8
Lit green: The server is mounted.
Blinking green: Data is being transferred.
e [PC5] Eject button
Press this to eject the SRMemory card.
f SRMemory indicator
Displays the status of the SRMemory card inserted in the
slot.
Off: The SRMemory card is logically detached from the
Lit blue: The SRMemory card is connected to the unit and
Lit green: Data is being read from the SRMemory card.
Blinking blue
Blinking green
Blinking purple
Blinking red
Fast blinking red
1) Blinking LED: Blinks at 1-second interval.
g SRMemory slot
Insert the SRMemory card here.
address mode (see page 13).
not connected.
and operating in VTR mode.
communication with the VTR is disabled. Restart the
unit and the VTR.
unit.
available for use.
1)
: The SRMemory card is logically being
attached to or detached from the unit.
1)
: Data other than audio and video
signals, such as file name changes, is being written.
1)
: Files are being deleted or formatting
is being performed from the menu.
1)
: Salvaging or formatting is being
performed in response to an error.
1)
: A problem was detected while
processing the SRMemory card. Eject or salvage the
card or perform the appropriate operation as instructed
by the message that appears.
Fast blinking LED: Blinks at 1/4-second interval.
Advertisement
Table of Contents
