ZyXEL Communications XS3700 Series User Manual page 39

Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION
VLAN Stacking This link takes you to screens where you can activate and configure VLAN stacking.
Multicast This link takes you to screen where you can configure various multicast features, IGMP
snooping and create multicast VLANs.
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services via external servers. The external servers can be either RADIUS
(Remote Authentication Dial-In User Service) or TACACS+ (Terminal Access Controller
Access-Control System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized DHCP and
ARP packets in your network.
Loop Guard This link takes you to a screen where you can configure protection against network loops
that occur on the edge of your network.
VLAN Mapping This link takes you to screens where you can configure VLAN mapping settings on the
Switch.
Layer 2 Protocol This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling)
Tunneling settings on the Switch.
sFlow This link takes you to screens where you can configure sFlow settings on the Switch.
PPPoE This link takes you to screens where you can configure how the Switch gives a PPPoE
termination server additional subscriber information that the server can use to identify
and authenticate a PPPoE client.
Errdisable This link takes you to a screen where you can configure CPU protection and error disable
recovery.
MAC Pinning This link takes you to a screen where you can set specific ports to have priority over other
ports in MAC address learning.
Private VLAN This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.
Green Ethernet This link takes you to a screen where you can configure the Switch to reduce port power
consumption.
LLDP This link takes you to a screen where you can configure LLDP settings.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
Policy Routing This link takes you to screens where you can configure policy routing rules.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking rules and
set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to screens where you can configure the DHCP settings.
VRRP This link takes you to screens where you can configure redundant virtual router for your
network.
ARP Setup This link takes you to a screen where you can configure ARP learning mode on a per-port
basis and create static ARP entries which do not age out.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and
configure SNMP and remote management.
Diagnostic This link takes you to screens where you can view system logs and can test port(s).
Syslog This link takes you to screens where you can setup system logs and a system log server.
Chapter 4 The Web Configurator
XS3700 Series User's Guide
39