Table of Contents
Advertisement
Figure 271 Management > Syslog > Server Setup
The following table describes the labels in this screen.
Table 211 Management > Syslog > Server Setup
LABEL
DESCRIPTION
Active
Select this check box to have the device send logs to this syslog server. Clear the check
box if you want to create a syslog server entry but not have the device send logs to it (you
can edit the entry later).
Server Address
Enter the IP address of the syslog server.
Log Level
Select the severity level(s) of the logs that you want the device to send to this syslog
server. The lower the number, the more critical the logs are.
Add
Click Add to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Clear
Click Clear to return the fields to the factory defaults.
Index
This is the index number of a syslog server entry. Click this number to edit the entry.
Active
This field displays Yes if the device is to send logs to the syslog server. No displays if the
device is not to send logs to the syslog server.
IP Address
This field displays the IP address of the syslog server.
Log Level
This field displays the severity level of the logs that the device is to send to this syslog
server.
Delete
Select an entry's Delete check box and click Delete to remove the entry.
Cancel
Click Cancel to begin configuring this screen afresh.
Chapter 45 Syslog
XS3700 Series User's Guide
384
Advertisement
Table of Contents
