Table of Contents
Advertisement
Figure 164 Advanced Application > Layer 2 Protocol Tunneling
The following table describes the labels in this screen.
Table 129 Advanced Application > Layer 2 Protocol Tunneling
LABEL
DESCRIPTION
Active
Select this to enable layer-2 protocol tunneling on the Switch.
Destination
Specify an MAC address with which the Switch uses to encapsulate the layer-2 protocol
MAC Address
packets by replacing the destination MAC address in the packets.
Note: The MAC address can be either a unicast MAC address or multicast MAC address. If
you use a unicast MAC address, make sure the MAC address does not exist in the
address table of a switch on the service provider's network.
Note: All the edge switches in the service provider's network should be set to use the same
MAC address for encapsulation.
Port
This field displays the port number.
*
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
CDP
Select this option to have the Switch tunnel CDP (Cisco Discovery Protocol) packets so that
other Cisco devices can be discovered through the service provider's network.
STP
Select this option to have the Switch tunnel STP (Spanning Tree Protocol) packets so that
STP can run properly across the service provider's network and spanning trees can be set up
based on bridge information from all (local and remote) networks.
VTP
Select this option to have the Switch tunnel VTP (VLAN Trunking Protocol) packets so that all
customer switches can use consistent VLAN configuration through the service provider's
network.
Chapter 28 Layer 2 Protocol Tunneling
XS3700 Series User's Guide
251
Advertisement
Table of Contents
