Table of Contents
Advertisement
Connecting the power cord.
1. Connect the power cord to the inlet on lower
left of the machine. (230 V specifications
only.)
2. Connect the power plug to the wall outlet.
Initial setting for the developer.
1. Turn on the power switch.
2. Enter 10871087 using the numeric keys to enter the maintenance mode.
3. Enter 130 using the numeric keys and press the start key.
4. Press the start key.
Installation of the toner is started. (Approximately 5 minutes)
Display
DLP SENS: Presence of toner inside developing unit (1: No/0: Yes)
TIME(SEC): When it becomes 3 minutes before an installation end, it will count up from 0 and will become an instal-
lation end by 180.
RESULT: Result of the installation (0: During installation/1: Installation is successful/2: Installation is failed)
If the installation is failed, execute U132 (Replenishing toner forcibly) (see page 1-4-34).
5. After driving stops, press the stop/clear key.
6. Enter 001 using the numeric keys and press the start key.
The machine exits the maintenance mode.
Make test copies.
1. Load paper in the cassette.
* When fixing the paper width guides position
of cassette 3 or 4, use M3 x 8 screws sup-
plied with the machine.
2. Make test copies.
1-3-10
M3 x 8
screws
Service Manual
Power cord
Figure 1-3-16
Paper width guides
Figure 1-3-17
M3 x 8
screws
Y104350-7
Advertisement
Table of Contents
