Table of Contents
Advertisement
Problem
(28)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
6).
Jam code 45
(29)
A paper jam in the
fuser section is indi-
cated during copying
(jam in fuser section
7).
Jam code 46
(30)
A paper jam in the
eject section is indi-
cated during copying
(jam in eject section).
Jam code 50
(31)
A paper jam in the
eject section is indi-
cated during copying
(jam in duplex feed-
shift section).
Jam code 60
(32)
A paper jam in the
duplex section is indi-
cated during copying
(jam in duplex inter-
nal tray).
Jam code 62
1-5-18
Causes/check procedures
Defective exit switch.
Defective exit switch.
Defective exit switch.
Defective exit switch.
Broken feedshift switch
actuator.
Defective feedshift switch.
Broken duplex feed switch
actuator.
Defective duplex feed
switch.
Check if the duplex switch-
back motor malfunctions.
Electrical problem with the
duplex switchback motor.
Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn the exit switch on and off
manually. Replace the exit switch if indication of the correspond-
ing sensor on the touch panel is not displayed in reverse.
Check visually and replace the feedshift switch if its actuator is
broken.
Run maintenance item U031 and turn the feedshift switch on and
off manually. Replace the feedshift switch if indication of the corre-
sponding sensor on the touch panel is not displayed in reverse.
Check visually and replace the duplex feed switch if its actuator is
broken.
Run maintenance item U031 and turn the duplex feed switch on
and off manually. Replace the duplex feed switch if indication of
the corresponding sensor on the touch panel is not displayed in
reverse.
Run maintenance item U030 and select the duplex switchback
motor on the touch panel to be turned on and off. Check the status
and remedy if necessary.
Check (see page 1-5-61).
Service Manual
Corrective measures
Y104350-7
Advertisement
Table of Contents
