6. Remove the connector and band inside the
scanner unit.
* Cut out the band using nippers.
7. Release the inserted parts of wire guide and
then remove the guide from the mirror 1
frame.
8. Remove two screws holding the exposure
lamp and then remove the lamp.
9. Remove the wire guide from the wire of the
exposure lamp.
10. Replace the exposure lamp.
11. After letting the wire of the exposure lamp
pass in the wire guide hole of the mirror 1
frame, refit the exposure lamp using two
screws.
Y104350-7
Connector
Band
Exposure lamp
Sevice Manual
Figure 1-6-66
Wire guide
Wire guide
Figure 1-6-67
Figure 1-6-68
Inserted parts
Wire guide hole
Exposure lamp
1-6-35