Table of Contents
Advertisement
(11) Adjusting the margins for scanning an original on the contact glass
Perform the following adjustment if the margins are not correct.
U402
(P. 1-6-28)
<Caution>
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
<Procedure>
Start
Enter maintenance mode.
Enter 403 using the numeric keys.
Press the start key.
Select the item
to be adjusted on the touch panel.
Press the interrupt key.
Press the start key
to make a test copy.
Are the margins correct?
Yes
Proceed to another mode?
Press the stop/clear key.
Exit maintenance mode.
End
Y104350-7
U404
U403
(P. 1-6-95)
Touch panel display
A MARGIN: Scanner left margin
B MARGIN: Scanner leading edge margin
C MARGIN: Scanner right margin
D MARGIN: Scanner trailing edge margin
No
Yes
No
Press the start key.
The new setting
is stored.
Change the setting.
Increasing the value using the cursor
up key makes the margin wider.
Decreasing the value using
the cursor down key makes the
margin narrower.
Setting range (initial setting)
Scanner left margin: 0.0 to +10.0 (+3.0)
Scanner leading edge margin: 0.0 to +10.0 (+3.0)
Scanner right margin: 0.0 to +10.0 (+3.0)
Scanner trailing edge margin: 0.0 to +10.0 (+3.5)
Changing the value by one moves
the margin by 0.1 mm for all.
Scanner leading edge margin (3 2.5 mm)
Ejection direction
(reference)
Sevice Manual
Scanner
left margin
+2.0
(2
mm)
-1.5
Scanner trailing edge margin
+
(3 2.5 mm)
-
Figure 1-6-103
+
-
Scanner
right margin
+2.0
(2
mm)
-1.5
1-6-55
Advertisement
Table of Contents
