®
Invacare
- PRONTO M41
8.1.4
Removing/Installing the swingarm assembly
Requirements:
● 24 mm open-ended wrench
● 19 mm socket wrench
● 13 mm socket wrench
● 11 mm socket wrench
Removing the swingarm assembly:
●
Remove the front caster assembly, as described in chapter 8.4.4
●
Remove the drive wheel, as described in chapter 8.5.
●
Ensure the front and top covers are removed. Refer to chapter 8.1.1 and chapter 8.1.2.
●
Remove the four screws (1) that secure the swingarm (4) assembly to the motor.
●
Remove the locknut (2) and spacer (3) that secure the swingarm (4) assembly and bracket (8)
to the frame (9).
Installing the swingarm assembly:
●
Install the locknut (2) and spacer (3) that secure the swingarm (4) assembly and bracket (8) to
the frame.
●
Install the four screws (1) that secure the swingarm (4) assembly to the motor (5).
●
Install the drive wheel, as described in chapter 8.5.
●
Ensure the front and top covers are installed. Refer to chapter 8.1.1 and chapter 8.1.2.
●
Install the front caster assembly, as described in chapter 8.4.4.
SERVICE MANUAL
39