Replacing The Acs2 Power Module - Invacare Pronto M41 Series Service Manual

SERVICE MANUAL
8.2.4

Replacing the ACS2 power module

Note
When replacing the power module in connection with a remote, please take the final selection of
the drive program into account as described in chapter 8.3.
Different power modules in connection with different remotes can be fitted to the mobility aid. The
possible power modules are described in chapter 4.2.
IMPORTANT!
Any changes to the drive program can affect the driving characteristics and the tipping
stability of the mobility aid!
• Changes to the drive program may only be carried out by trained Invacare® specialist
dealers!
• Invacare® can only give a warranty for safe mobility aid driving behaviour - especially tipping
stability - for unaltered standard drive programs!
Note
All power modules are delivered with a standard drive program. If you have made any customer-
specific modifications to the drive program, these must be adapted after the installation of the new
power module.
Requirements:
● 8 mm socket wrench
● To adapt the drive program:
programming software or hand programming device and system installation manual, available
from Invacare®.
Removing the power module:
● Switch the electronics OFF on the remote.
● Remove the seat, as decribed in chapter 8.9.1.1.
● Move the seat into the service position (Modulite seat), as described in chapter 8.9.2.1.
● Remove the rear cover and top cover, as described in chapters 8.1.1 and 8.1.3.
● Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
● Disconnect the plugs (2) from the power module (1).
44
®
Invacare - PRONTO M41