Updating The Driving Program - Invacare Pronto M41 Series Service Manual

®
Invacare - PRONTO M41
● Remove the power module from the frame.
● Reverse the steps to install the new power module.
Note
Route the joystick cable (not shown) through the hole in the top cover (not shown) when installing
the new power module.
Route the joystick cable, two battery cables, and the motor cable beneath the tabs.
8.3

Updating the driving program

The driving programs for power wheelchairs are continually updated and improved by Invacare®.
For this reason, you should check whether the version number is still up to date each time a
wheelchair comes in for repairs, and also during regular inspections.
If a newer version is available, the driving program must be updated. The procedure for updating
the driving program is described in the user manual of the Wizard software.
Note
The electronic system is supplied with a standard drive program. If the driving program has been
customised, you have to perform this customisation again, after installing the new driving
program. This also applies to the customer-specific options of the seat setting for ACS2 remotes,
which are activated ex works.
WARNING!
Every alteration to the drive program can influence vehicle handling and the tipping
stability of the wheelchair!
• Alterations to the drive program must only be carried out by trained Invacare®-dealers!
• Invacare® can only assume a warranty for the safe vehicle handling of the wheelchair – in
particular tipping stability - for unaltered standard drive programs!
Pre-requisites:
● Dynamic® Wizard software
● User manual for the Wizard software
● For further information on other requirements - such as the minimum system configuration of
the PC to be used for programming, necessary programming cables - see the user manual of
the Wizard software. You find the latest version of the user manual in the download area on
http://www.dynamiccontrols.com/.
Note
When an electrical adjustment option is retrofitted, such as electrical legrests, then this option
needs to be activated in the driving program as well if you have an ACS2 remote. For more
information, refer to the user manual of the Wizard software and the installation instructions for
the electronic modules
SERVICE MANUAL
49