D-Link DAP-1150 User Manual page 27

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual
When the device is switched to the router mode, the Connect to internet, Host site, Configure
Wi-Fi, Configure manually, and Logout buttons are available on the page.
To configure connection to the Internet, click the Connect to internet button. After clicking the
button, the Internet Setup Wizard opens (see the Internet Setup Wizard section, page 71).
To configure access from the Internet to a web server located in your LAN, click the Host site
button. After clicking the button, the Site Setup Wizard opens (see the Site Setup Wizard section,
page 93).
To configure the access point's wireless network, click the Configure Wi-Fi button. After clicking
the button, the Wi-Fi Setup Wizard opens (see the Wi-Fi Setup Wizard section, page 94).
To get back to the quick settings page from any Wizard or web-based interface menu section, left-
click the D-Link logo in the top left corner of the page.
To configure all parameters of the access point independently without the Wizards, click the
Configure manually button.
After clicking the Configure manually button the system statistics page opens. The page displays
general information on the access point and its software (the version and the date of the firmware,
the IP address of the device, the name of the WLAN, etc.).
Figure 19. The quick settings page in the router mode.
Page 27 of 175
Installation and Connection