Creating Pppoe Wan Connection - D-Link DAP-1150 User Manual

DAP-1150 Wireless Access Point Supporting Router Mode
User Manual

Creating PPPoE WAN Connection

To create a connection of the PPPoE type,
opened page, select the PPPoE value from the Connection Type drop-down list and specify the
needed values.
Figure 97. The page for creating a new connection. The General settings and Ethernet sections.
Parameter
Port
Name
Enable
Direction
MTU
MAC
click the Add button on the Net / WAN page.
General settings
A physical interface to which the new connection will be assigned.
A name for connection for easier identification.
Select the checkbox to enable the connection.
The direction of this connection.
Ethernet
The maximum size of units transmitted by the interface.
A MAC address assigned to the interface. This parameter is
mandatory if your ISP uses MAC address binding. In the field, enter
the MAC address registered by your ISP upon concluding the
agreement.
You can click the Clone MAC button to set the MAC address of
the network interface card (of the computer that is being used to
configure the access point at the moment) as the MAC address of
the WAN interface.
Also you can set the address of a device connected to the access
point's LAN at the moment. To do this, select the relevant value
from the drop-down list located to the right of the field (the field
will be filled in automatically).
Page 104 of 175
Configuring Device (Router Mode)
Description
On the