Siemens Gigaset C1 User Manual page 118

Activating/deactivating internal call forwarding
Precondition: Internal call forwarding can only be activated if the forward destination
is set up.
v
s í
s
Int. call forw.
~
OK
either ...
Activate?
or ...
Deactivate?
Defining the number of rings
When ring delay is used, the number of rings before the call is forwarded must be
defined. Between 0 (= immediate call forwarding) and 9 rings can be set. There are
5 seconds between rings.
The factory default setting is 0 rings (= immediate call forwarding).
v
s í
s
Forward. base
~
OK
s
No. of rings
~
OK
a
Forwarding external calls – CF (Call Forwarding)
Your ISDN connection offers you two telephone lines (B channels) that you can use at
the same time. It is therefore possible to activate call forwarding not only in the tele-
phone exchange (external), but also directly in the base (internal). By this means a caller
is forwarded to the destination you specify via the second telephone line. You can set
the location for call forwarding as follows:
so that the call is forwarded in the telephone exchange (external call diversion); this
◆
keeps your telephone lines free;
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 91).
Activate:
Confirm.
OK
Deactivate:
Select the menu item and confirm.
OK
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 91).
Select the menu item and confirm.
OK
Enter the number of rings and confirm.
Hold down (return to idle status).
System settings
117