Panasonic KX-TVP50 Installation Manual page 64

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
Possible causes of the message: "APT Interface Connection is not Established"
The PBX is not a correct type. Since the VPS is
configured to communicate with the KX-TA
series under APT Integration, this message will
always appear when connecting to another type
of PBX.
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected.
The PBX is a correct type but does not have the
proper software level to support APT/DPT
Integration.
The PBX is not programmed properly to support
APT/DPT Integration.
10.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven programme.
11.
Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] then
QSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.
CAUTION
When 2 VPSs are connected to the KX-TA series, the following 2 procedures should be done
to make the VPSs work correctly.
1.
64
Cause
Delete a mailbox in either VPS so that each extension has only ONE MAILBOX.
After Auto Configuration has been executed, an extension has a mailbox in both
VPS1 and VPS2. However each extension can have a maximum of 1 mailbox in
either VPS. To delete a mailbox, Type [D] (Delete) in the "Make (Make/Delete)"
field (see "Step 4 Creating Mailboxes" in 5.1.3 Starting the Quick Setup).
The extension should assign a Voice Mail extension from the VPS which contains
its mailbox as the destination for Call Forwarding and Voice Mail Transfer. DO
NOT assign a Voice Mail extension from the other VPS. For example, if jack 06
(extension 106) has its mailbox in the VPS1, assign extension 107 or 108 as the
destination, not extension 115 or 116 (see diagram below).
Table 15
Connect a correct PBX and set
the PBX type by using Quick
Setup (see Section 5
CUSTOMISING THE
SYSTEM).
Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
Consult your dealer or use
Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
Action
Installation Manual