Panasonic KX-TVP50 Installation Manual page 245

Parameter
Message
Waiting Lamp
Ports
Message
Waiting Lamp
for Every
Message
Max. Digits for
Callback No.
Callback No.
Entry Interdigit
Time-Out
System
Callback No.
Installation Manual
Value Range
(Default)
Port No. Specifies the port numbers used for the Message Waiting
(1-2) Notification Lamp feature.
The VPS turns on the Message Waiting Lamp of the
extension using the port specified in this parameter. At
least 1 port must be specified.
1. No If set to "Yes", the VPS will turn on the Message Waiting
2. Yes Lamp of the extension each time a new message is
(Yes) recorded in the mailbox. This will occur even if the
Message Waiting Lamp was not turned off from a
previous message. This setting is useful when the first
attempt is unsuccessful.
If set to "No", the VPS will turn on the Message Waiting
Lamp for the first message only. The VPS will not turn on
the lamp for subsequent messages until the subscriber has
accessed the VPS to retrieve the messages stored there.
1-48 digits Specifies the maximum number of digits the caller can
(20) enter as a callback number. This number will display on
beepers if the "Beeper Callback No. Entry Mode" is
enabled.
1-10 s Sets the maximum allowable time between each digit on
(5) Beeper Callback No. Entry. If the caller does not enter
any digits within the specified time, the VPS will not
accept entry of any additional digits.
Up to 32 digits Specifies a telephone number that will display on the
(None) subscriber's beeper as a callback number. The callback
number entry mode "X" must be included in the
telephone number.
Note: If "Beeper Callback No. Entry Mode" is enabled
through COS, the callback number entered by the caller
will display on the destination beeper. However, if the
caller fails to enter a callback number, the System
Callback No. will display instead.
SYSTEM ADMINISTRATOR'S GUIDE
Table 61
Description/Function
245