Initialising The System - Panasonic KX-TVP50 Installation Manual

SYSTEM MAINTENANCE AND TROUBLESHOOTING

7.1 INITIALISING THE SYSTEM

Initialising the system clears all voice data except user prompts and returns all system
parameters to their default settings. Throughout this section, menu selections are indicated as
"System Administration Top Menu-(Selection Number)". This means that the System
Administration Top Menu must first be accessed. On the first menu displayed, make the menu
selection corresponding to the first menu displayed. Repeat this process for each subsequent
menu when additional selection numbers are listed.
To initialise the system, follow the menu path as shown:
System Administration Top Menu-4
1.
Go to the System Administration Top Menu
1 : Program
2 : System Reports
3 : Utility Command
4 : System Reset/Clear
5 :Quick Setup (VT100 Mode Only)
Enter the number: =
2.
Type [4] for System Initialisation.
System Reset/Clear Menu
1. Mailbox No. Length [3]
2. System Manager's Mailbox No. [999]
3. Message Manager's Mailbox No. [998]
Will you change the settings ? (Y/N): =
Note
Depending on the PBX extension numbering, the "Mailbox No. Length" might be 2
to 5.
3.
Type [Y] (this places the VPS in the off-line mode).
System Reset/Clear Menu
1. Mailbox No. Length [3] (2 - 5) : =
2. System Manager's Mailbox No. [999] : =
3. Message Manager's Mailbox No. [998] : =
Are these parameters acceptable ? (Y/N) : =
124 Installation Manual