Appendix A: Installing The Tool Strip; Installing The Controller Unit And Stylus Holder - Smart Technologies Smart Board Plasma Display Installation Manual

Appendix A: Installing the Tool Strip

If you prefer not to use the SMART Pen Tray, you can purchase an SBPD that includes a Tool
Strip, a controller unit, and a stylus holder with one stylus. The Tool Strip makes a wide range
of touch, display and annotation functionality easily accessible from the SBPD frame area.

Installing the Controller Unit and Stylus Holder

1. Holding the controller in a vertical position, place it on the right side of the overlay frame,
with the attachment tab facing the center of the overlay. Using the small hex key and two
hex screws from the accessory box, secure the controller to the overlay frame by the
attachment tab.
2. Maneuver the overlay so that its bottom edge hangs slightly over the edge of the table.
Holding the stylus holder in a vertical position, place it on the lower edge of the overlay
frame with the attachment tab facing the center of the overlay. Using the small hex key and
two hex screws from the accessory box, secure the stylus holder to the overlay frame by
the attachment tab.
26
Attaching the Controller to the Overlay
Attaching the Stylus Holder to the Overlay
SBPD Installation Guide
Controller Unit
Attachment Tab
SBPD Overlay
Overlay Frame
Stylus Holder