Installing And Connecting A Computer - Smart Technologies SMART Board 4000i Installation Manual

Rear projection
Hide thumbs Also See for SMART Board 4000i:
Table of Contents

Advertisement

5. Open the cabinet's front doors. Unbuckle and remove the strap that secures the small mirror
located in the middle of the speaker panel, below the projector platform.

Installing and Connecting a Computer

To install and connect a computer
1. While facing the front of the cabinet, slide the computer into place at the right-hand side of the
cabinet, above the computer straps. Use the straps to secure the computer.
NOTE: The computer straps enable you to roll the cabinet from room to room without having
to remove the computer. However, these straps won't secure the computer during cabinet
shipment. If you need to transport the 4000i, remove the computer before you ship it.
2. Locate the tie-wrapped bundle of cables dangling inside the cabinet. There are also power,
keyboard and mouse cables located nearby.
6
Serial
Audio
Video
Printer
Setting Up the 4000i
Remove this strap.
Network
Keyboard
Mouse
99-00582-20 REV A0

Advertisement

Table of Contents
loading

Table of Contents