Table of Contents
Advertisement
Preparing to Install Your Interactive Whiteboard
Before you install the screen in the wall opening, complete the following tasks:
•
remove the mirror stand from the pallet (2876 and 2976 only)
•
install SMART Board software
Removing the Mirror Stand from the Pallet (2876 and 2976 only)
If you ordered a 2876 or 2976 interactive whiteboard, you also received an NEC VT676 projector
and a mirror stand. Follow the instructions below to remove the mirror stand from the pallet.
To remove the mirror stand from the pallet
1. Remove the two wing nuts on the rear brackets that hold the unit to the pallet.
2. Remove the bolts that hold the brackets to each corner of the pallet. To do this, use one of the
two 9/16" combination wrenches that you'll find on the right side of the mirror stand with the
other hardware.
3. Roll the mirror stand down the pallet ramps.
Installing SMART Board Software
Before you install and connect your interactive whiteboard, you need to install SMART Board
software. SMART Board software contains the tools you need to control any computer application
and write over it. For complete details on this software, refer to the SMART Board software online
Help.
CAUTION
To install SMART Board software
•
Insert the SMART Board software CD into your CD drive.
•
Follow the on-screen instructions.
If the installation program doesn't start automatically, navigate to the installation folder on the
CD, double-click the setup.exe file, and follow the on-screen instructions.
99-00479-03 REV B0
Don't connect the SMART USB adapter cable to the computer until after you've
installed SMART Board software.
If you do this by accident, the Found New Hardware wizard appears. Click the
Cancel button in the wizard, unplug the SMART USB adapter cable from the
computer and then install SMART Board software.
Preparing to Install Your Interactive Whiteboard
3
Advertisement
Table of Contents
