Table of Contents
Advertisement
Installing Your 2000i
This section of the manual describes how to:
•
set up the 2000i (page 8)
•
install and connect the host computer (page 10)
•
adjust the projected image (page 13)
•
connect the videoconferencing/laptop shelf (page 20)
•
install SMART Board software (page 22)
•
connect a guest laptop (page 24)
•
connect a VCR or DVD player (page 24)
•
connect an external sound system (page 26)
•
connect an external projector or monitor (page 27)
Setting Up the 2000i
1. Remove the unit from its shipping carton. (To do this, follow the Unpacking Instructions.)
Unpack the remaining contents of the shipping carton and wheel the unit to a location that's
within reach of a power source. Leave enough space around the unit to comfortably perform the
assembly and connection procedures in the pages that follow.
2. Lock the casters by pressing down on the caster-lock tab; unlock the casters by pressing up on
this tab, as shown in the figure below.
3. Extend all four anti-tip feet. You'll see two holes on the outer side of each leg. To extend the feet,
depress the locking ball in the inner hole, and then pull the leg out until the locking ball engages
in the outer hole.
8
A Locked and Unlocked Caster
Locking Ball in the
Inner Hole
Extending an Anti-Tip Foot
2000i-DVX Installation Guide
Locking Ball in the
Outer Hole
Advertisement
Table of Contents
