Saturn KDB - 161 GOM Manual page 77

14 - 5
Crevice between electrode
2~3 mm
No Symptoms and Causes
1 Too many ignition noise during ignition.
2 Ignition noise due to delayed ignition.
3 Noise during combustion.
4 Boiling noise.
Others Failure
<Fig. 1>
- Replace the ignition transformer if it
- The flue bends and length may be above
- Boiling noise may occur when the heating
Band Cl a mp
<Fig. 2>
Solutions
- There is too much gas during the initial ignition.
Adjust the primary gas pressure according to
regulations.
- Space between electrodes is too close or too
far away. Adjust the space (2~3mm) between
them.
discharges.
regulations (3 elbow 5.0m) and in case of a
FF flue the airtight chamber may be damaged
causing a flow of waste gas to the suction
area. Check the flue and replace if needed.
water temperature goes beyond a certain
point due to uncleanness of the heating water
or a defect in the welding of the main heat
exchanger brazing. Clean the heating water
and replace the main heat exchanger.
- 77 -
KDB-GOM
Too much noise
Nai l
Band Cl a mp
Screw
(Scheme of the
air i n take hose i s omi t ted)
Reference
<Fig. 1>
<Fig. 2>
<Fig. 3>
Series
<Fig. 3>