Figure 1.15 Additional Remote Temp Sensor Install - Bard D36A2P/BLD.10304 Installation And Service Instructions Manual

"0". This is the default setting. For information on checking the remote indoor temperature sensor configuration, see
Configuring Additional Remote Indoor Temperature Sensors on page 51.
For unique situations involving temperature flux within the shelter, up to two (2) additional sensors may be
purchased and installed to provide temperature-averaging or highest-temperature protection (see Figure 1.15).
Please see Configuring Additional Remote Indoor Temperature Sensors on page 51 in the Service section of this
manual to set up the additional remotes.
Up to two (2) additional sensors may be purchased and installed for averaging or highest-temp mode. Use
terminals #13, #14, #15 and #16. These connections are not polarity-sensitive.
FIGURE 1.15
Additional Remote Temperature Sensor Installation
Optional Additional
Remote Sensor
Remote Sensor
Optional Additional
Remote Sensor
Manual 2100-620A
Page 23 of 107