Figure 7 Install Outdoor Air Sensor; Figure 12 Pull Wire Into Exhaust Area And Fasten With Ties; Figure 13 Install Economizer; Figure 14 Control Plug Centered In Plug Access Opening - Bard ECON-NC5 Installation Instructions Manual

Pull the excess sensor wire down into the exhaust area
and fasten with two (2) 7950-004 ladder ties.
FIGURE 12
Pull Wire into Exhaust Area and Fasten with Ties
Before installing, remove economizer from packaging
and verify there is no damage. Install the economizer as
shown in Figure 13.
Set economizer on the exhaust partition (see Figure 5
on page 5) and slide in until flush with the side of the
wall mount. Economizer can be installed from either
side.
FIGURE 13
Install Economizer
When the economizer is fully installed, the control plug
should be centered in the plug access opening on the
front panel of the economizer as shown in Figure 14.
FIGURE 14
Control Plug Centered in Plug Access Opening
From the front, through the filter opening, plug the
economizer power plug into the control panel plug (see
Figure 15).
IMPORTANT: Sharp edges--PPE required.
FIGURE 15
Connect Economizer Power Plug to

Control Panel Plug

Manual 2100-708A
Page 7 of 17