Setup; Powering Up The Projector; Power Switch; Switch On Sequence - Barco Galaxy NH-12 User Manual

5. SETUP

Overview
•

Powering up the projector

• Starting up the projector
• Setting up the Remote Control Unit address
• Setting up the projector address (only if necessary)
• Setting up the orientation
• Adjusting the lens
• Setup the baud rate for serial communication
• Preferences
• Setup of the Linked projectors in a Multichannel system
5.1 Powering up the projector
How to power up the projector ?
1. Switch the power switch to "1"
R / PR R / PR G / Y G / Y B / PB B / PB Hs / Cs Hs / Cs
DVI DVI COMPUTER COMPUTER
IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
L1 L1 L2 L2
STEREO INPUT STEREO INPUT
RS 232 C RS 232 C
DESKTOP INPUT DESKTOP INPUT
Image 5-1

Power switch

2. The software will be initialized. This may take up to 30 seconds. During this phase the LCD display is lit (1). The initialization is
followed by the keypad lighting up briefly (5 seconds) and the projector Standby status (2) .
Galaxy NH-12
Image 5-2

Switch ON sequence

R59770122 BARCO GALAXY NH-12 04/05/2011
Vs Vs VIDEO VIDEO S-VIDEO S-VIDEO
IN1 IN1 IN2 IN2
L3 L3
STEREO OUTPUT STEREO OUTPUT
DVI DVI R.C. R.C.
1
0
standby
1
2
5. Setup
41