Stereo Connections; Stereo Input Connections - Barco Galaxy NH-12 User Manual

The projector can be connected to a LAN or can be connected to a desktop PC via a crossed cable (as indicated
above).
The desktop can be enabled/disabled, "Desktop", page 125
Using the desktop input makes only sense when using the Barco Desktop integration software. The Desktop
integration software is covered in the Desktop integration User Guide.

4.5.10 Stereo connections

What can be done ?
The stereo sources sync signals have to be connected to the 4th layer of the front panel. The stereo input layer holds 6 mini DIN
connectors and 2 BNC connectors.
The 6 mini DIN connectors are the stereo sync input connections for respectively from the left to the right, the 1
The order is from left to right eg. for the DVI input board, the left DIN connector (L3/IN1) is for the left connector on the DVI input
board and the right DIN connector (L3/IN2) is for the right connector on the DVI input board.
Image 4-23

Stereo input connections

The BNC connectors are the stereo output sync signals. These signals will drive the emitters in case of active stereo projection
using active stereo glasses. The fact that the projector is providing two BNC is to allow the linking (stereo synchronization) of several
projectors in a multichannel projection system (see Multichannel installation).
The 2 BNC's are identical i.e. it does not matter to which BNC the emitter is connected.
How to connect the stereo input and output signals ?
1. Connect the mini-din male connector(s) to the projector's female mini DIN connector(s)
R59770122 BARCO GALAXY NH-12 04/05/2011
R / PR G / Y G / Y G / Y B / PB Hs / Cs Hs / Cs Hs / Cs Vs VIDEO VIDEO VIDEO S-VIDEO S-VIDEO S-VIDEO
R / PR R / PR B / PB B / PB Vs Vs
DVI COMPUTER
DVI DVI COMPUTER COMPUTER
IN1 IN1 IN1 IN2 IN2 IN2 IN1 IN1 IN1 IN2 IN2 IN2 IN1 IN1 IN1 IN2 IN2 IN2
L1 L1 L1 L2 L2 L2 L3 L3 L3
STEREO INPUT STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT STEREO OUTPUT
RS 232 C DVI R.C.
RS 232 C RS 232 C DVI DVI R.C. R.C.
4. Installation
,2 and 3 layer.
st nd rd
29