9. Troubleshooting
9.2
Troubleshooting using the OSD
What can be done ?
The projector bus allows the diagnostic of different hardware components divided in two main groups.
•
I
C diagnostics : a number of internal electronic boards can be diagnosed and a graphical interface shows whether an error is
2
•
Lamps and power supply : lamp temperature and power related failures are logged and can be checked at any time.
•
Formatter : Allows to monitor the status and communication of the formatter and satellites
•
Cooling : the measured temperatures can be monitored as well as the different fan speeds
Display mode : allows to monitor the signal characteristics (frequency and mode) at the last image process stage (display)
•
•
Warning messages : setting the warning messages ON will allow to receive on screen warning messages
How to display the I
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Diagnostics
5. Press → to pull down the menu
6. Use ↑ or ↓ to select I
Image 9-2
A text box is displayed
Image 9-3
How to display the Lamps and power supply diagnostic menu ?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Diagnostics
5. Press → to pull down the menu
6. Use ↑ or ↓ to select Lamps and power supply and press ENTER
202
C diagnostics menu ?
2
2
C and press ENTER
R59770122 BARCO GALAXY NH-12 04/05/2011